5:39 am
Built lower control arms (adjustable and rebuildable) as my stock ones don't like me anymore. These will be reused when I make long arms next year as I need to get through the winter.
I couldn't install today b/c 1 of the 4 bolts in the stock arm was talking back to Bill 😛 (did not want to resign itself).
4:34 pm
January 27, 2011
Offline HEY, those look GOOD!! I think you'll get tired of looking at them before they break.
=====
If you do not change direction, you may end up where you are heading -- Lao Tzu
3:58 am
September 25, 2011
Offline
Very nice..
4:14 pm
May 4, 2004
Offline Nice work
12:54 am
Thank you much. I got some great advice from Rick on welding these up as you gotta be careful not to overheat the inserts. Resulted in doing 1 root pass and 2 cover passes. I flapped after pass 2 so that pass 3 would be the finish. I was able to get them installed today as Bill would not be defeated by the one bad bolt.
2:50 am
The arms turned out great! That bolt was stuborn, we had to get out the biggest hammer. (Bfh, 8lb sledge). Good job Carl!
3:01 am
Club Member
September 3, 2008
Offline Can you make a 2nd set for my dodge? Please!!!
Um...what?
3:04 am
Club Member
January 19, 2011
Offline Nice work Carl. Well done! They look strong enough.
Semper Fi
3:20 am
Looks good Carl. Sorry I couldn't check them out when you were welding them up. Works been crazy. It looks like you did just fine though.
1 Guest(s)
